No Airflow through Panel Vents when Panel/Floor Mode is Selected – 2015 Ford Focus

ELECTRONIC MANUAL TEMPERATURE CONTROL (EMTC) – NO AIRFLOW FROM PANEL VENTS WHEN PANEL/FLOOR MODE SELECTED – BUILT ON OR BEFORE 7/24/2015

 

FORD:

2015 Focus

 

ISSUE:

Some 2015 Focus vehicles equipped with EMTC and built on or before 7/24/2015 may exhibit no airflow through the panel vents when panel/floor mode is selected.

 

ACTION:

Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

1. Check the vehicle build date. Was the vehicle built on or before 7/24/2015 and equipped with a 1.0L gasoline turbocharged direct injected (GTDI) engine?
   1. Yes – reprogram the heating ventilation air conditioning (HVAC) module using IDS or Ford J2534 release 97.02 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com.
   2. No – proceed to Step 2.
2. Was the vehicle built on or before 7/24/2015 and equipped with a 2.0L gasoline direct injected (GDI) engine or 2.0L GTDI engine?
   1. Yes – replace the HVAC control module. Refer to Workshop Manual (WSM), Section 412-00.
   2. No – this article does not apply. Refer to WSM, Section 412-00.

 

F1EZ-19980-T	HVAC Control Module – Without Heated Seats
F1EZ-19980-U	HVAC Control Module – With Heated Seats

 

---

 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

• Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
• Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com