| “This site contains affiliate links for which OEMDTC may be compensated” |
2015 Edge – To Drive: Press Brake And Start Button Message After Genuine Ford Accessory Remote Start Installation
After installation of a Genuine Ford Accessory remote start system, some 2015 Edge vehicles can exhibit a To Drive: Press Brake and Start Button message that stays illuminated in the Instrument Panel Cluster (IPC) message center after a remote start session is completed.
After cycling the ignition key, the message may still be illuminated in the IPC message center.
Update the IPC module to the latest level calibration using IDS or Ford J2534 version 95.04 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
