Instrument Panel Cluster (IPC) Off-Road Display Screen Flicker – 2016 Ford F-150

NHTSA ID Number: 10115960 Manufacturer Communication Number: SSM 46720   Summary Some 2016 F-150 vehicles may exhibit the off-road display flickering in the IPC. Reprogram the IPC using Integrated Diagnostic System (IDS) release 106.03 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also … Read more

Unable To Shift Out Of Park And Possible No Crank – 2017 Ford F-150/Raptor

2017 Ford F-150

NHTSA ID Number: 10115957 Manufacturer Communication Number: SSM 46708 Summary Some 2017 F-150/Raptor vehicles equipped with a 10R80 transmission built on or before 22-May-2017 may exhibit unable to shift the transmission out of park and possible no crank. This may be due to an undersized manual shaft-to-TR sensor roll pin becoming dislodged. Discard old manual control shaft-to-TR … Read more

Intermittent Lack Of Steering Assist – Multiple Illuminated Warning Indicator Lamps – 2015-2017 Ford F-150

2015-2017 F-150 – Intermittent Lack Of Steering Assist – Multiple Illuminated Warning Indicator Lamps Some 2015-2017 F-150 vehicles may exhibit multiple illuminated warning indicators and a intermittent lack of steering assist.   Prior to performing any diagnosis or repair, visually inspect the 3C221 wire harness near the air compressor pulley for possible damage.    

New Valve Covers On Service Engines And Remanufactured Long Blocks – 2010-2017 Ford F-Series

2010 Through 2014 F-150, 2017 F-650/750 And 2011 Through 2016 F-250/350 With 6.2L Engines. New Valve Covers On Service Engines And Remanufactured Long Blocks. When replacing an engine with a long block (6006) assembly it will be necessary to install the valve covers, from the original equipment engine if the original engine was equipped with … Read more

8” Instrument Panel Cluster (IPC) Display – Software Installation Failures – 2017 Ford F-150

2017 F-150 Vehicles Equipped with an 8” Instrument Panel Cluster (IPC) Display – Software Installation Failures. NO FURTHER IPC MODULE PROGRAMMING SHOULD BE ATTEMPTED AT THIS TIME.   Contacts to the Technical Assistance Center and the Special Service Support Center indicate software installed using IDS level 105.03 or later risk blanking the IPC module. Engineering … Read more