6.7L Diesel – Tick/Tap Noise At Idle – 2011-2022 Ford F-Super Duty

2022 Ford F-Super Duty

NHTSA ID Number: 10228867 Manufacturer Communication Number: SSM 51251 Summary Some 2011-2022 F-Super Duty vehicles equipped with a 6.7L diesel engine may exhibit a ticking noise at idle after an engine oil change. It is often referred to as Typewriter Noise because of its similarity to the sound of a mechanical typewriter. When engine temperatures reach 150 … Read more

Rear Axle Chatter On Turns – 2004-2016 Ford with Dana 70 or Dana 80 Trac-Loc Limited-Slip Differential

2004-2016 Econoline/F-Super Duty with Dana 70 or Dana 80 Trac-Loc Limited-Slip Differential – Rear Axle Chatter On Turns Some 2004-2016 Econoline/F-Super Duty with a Dana 70 or Dana 80 Trac-Loc Limited-Slip Differential may exhibit a rear axle chatter during turns.   If normal diagnosis leads to differential clutch chatter as the cause, engineering recommendation is … Read more

Factory Trailer Brake Controller Installation – 2011-2014 Ford F-150

2011-2014 F-150 – Trailer Brake Controller Installation If a Dealership is installing a factory Trailer Brake Controller (TBC) on a 2011-2014 F-150, instructions are available in the Workshop Manual, Section 206-10 or on the Ford Accessories Website.   Once TBC is installed, use IDS 70.02 or later to configure the Instrument Cluster (IC) for TBC. … Read more

Front Window Sits Above The Glass Molding After Regulator Replacement – 2011-2014 Ford F-150

2011-2014 F-150 – Front Window Sits Above The Glass Molding After Regulator Replacement Some 2011-2014 F-150 vehicles may exhibit a front window that stops opening approximately 6.35mm-9.52mm (1/4″-3/8″) above the bottom window glass molding after window regulator replacement.   This is a normal operating characteristic of the new power window regulator and motor assembly. The … Read more

Proper Seating of Connector C2280G to the Body Control Module (BCM) – 2011-2014 Ford F-150

Proper Seating of Connector C2280G to the Body Control Module (BCM) GSB Showing how to verify a proper connection of connector C2280G to the Body Control Module (BCM).   See GSB: G0000071 for details.     Service Information & Reprogramming Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), … Read more