| TSB 14-0115 | ALL WHEEL DRIVE (AWD) TERRAIN MANAGEMENT INOPERATIVE – BUILT ON OR BEFORE 5/16/2014 |
This article supersedes TSB 12-8-9 to update the production fix date, vehicle model years, Issue Statement and Service Procedure.
ISSUE:
Some 2011-2014 AWD Explorer vehicles built on or before 5/16/2014 may exhibit a Terrain Management pop-up warning in the instrument cluster without an accompanying diagnostic trouble code (DTC) in the all terrain control module or anti-lock brake system (ABS) module.
ACTION:
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
- Reprogram the ABS module to the latest calibration using IDS or Ford J2534 release 90.02 and higher. Calibration files may also be obtained at www.motorcraft.com.
- Perform interactive vehicle dynamics (IVD) initialization using IDS.
| OPERATION | DESCRIPTION | TIME |
|---|---|---|
| 140115A | 2011-2014 Explorer AWD: Reprogram The ABS Module And Initialize The IVD Sequence Includes Time To Clear Codes After Repair (Do Not Use With Any Other Labor Operations) | 0.2 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| 2C219 | 04 |
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
